Bridge wireless network settings and Microsoft Windows XP
September 4th, 2010To connect with more than two computers on a wireless network bridge, you must first install an adapter cable for each computer, and after this course a CAT5 link them all to a hub or switch. The computer that thinks, or use to fill WAP types of adapters are connected in two ITS board: a normal LAN adapter, you should have already put in and a wireless adapter to connect the article> Wireless Access Point.
Well, we this step by step through the process. When you want to have installed and connected to the network adapter on your computer, go to the bridge and open the Control Panel> Network and Internet Connections> Network Connections Use. Remember that in order to create a wireless network bridge processes at least, you need 2 connections, which use different. These processes are ICF (Internet Firewall) and ICS (InternetSharing).
You should now be in the "Network Connections" and you should see some connections. Well, actually, each of these compounds is each of your network cards – one for radio and one for a wired one. Now open the card to go for wireless connection and go to the area shown in detail. You'll see that it works perfectly. Now, it is recommended that the Ethernet connection and also to review, and should work fine as well. Now,All you need do is click the two connections simultaneously (this is by holding down the Ctrl key and select Each link that you have done), then right click on any link and select Bridge Connections submenu. After the computer has finished the port configuration Bridge, a window of network connection.
ICS and ICF
I'm somewhere above that, a bridge, you must choose only that these connections are not used by thatICS and ICF. I also have to remember that for ICS ICS and ICF stands for Internet Connection Firewall. Of course, you can ICS or ICF, in some cases. Whatever the reason, you must first third tab. In other words, if you really need ICS ICF Have you as the local computer hardware store and even a new adapter card. But even with three adapters, the task is quite difficult to do because in order to bridge this way (trying toenable ICS or ICF, or both) before the bridge, each of them. Read http://www.howtosetupwirelessnetwork.com
You can always use the setup wizard for this task, but the order is required. First use the setup wizard to create the bridge and then enable ICS or ICF. Now the wizard to search for an Internet connection and you try to configure ICF and finally, if you want more network bridges, which are connected to the network.






